Installation:
1. Pour concrete slab on top of ground – minimum 23” wide x 39” long x 5-1/2” thick. In the center of the concrete slab leave a hole 12” x 12” to bring underground water line up through.

2. For best results – use a 10-14" diameter plastic, or corrugated, pipe. (Pipe should be 18” below bottom
frost line), leave this hole open for water line and air space.
NOTE: Do not allow concrete to be in contact with water supply line.

3. Insulate around pipe with Reflectix unfaced reflective roll insulation, or equivalent. This will keep the cold and frost from getting under drinker, having 45-48F., underground air temperature rising into drinker year round keeps drinker from freezing in winter and cooler on hot summer days.

4. Fasten ‘L’ brackets to drinker with short bolts in four (4) corners.

5. Set drinker on concrete slab – drill 3/8” holes for brackets into concrete slab. Before fastening drinker to slab, place foam gasket around outside of drinker, between drinker and concrete slab. NOTE: Very Important: to seal with a heavy bead of silicone caulk, inside and out, all around top of underground hole, so this seals the bottom of drinker.

6. Install 3/4" plastic pipe coming to drinker, leave approximately 10” of pipe sticking out from the top of your concrete base.

7. Shortcut installation – after main water line is cut to exact length, fasten valve fittings to main water line,
all except orange valve and assembly. Then take drinker and telescope over top of main water line. After drinker is in place on concrete, fasten orange valve and assembly.

NOTE:
Do not use any steel pipe.
Do not allow concrete or pipe to be in contact with water supply line.
Pipe clamps & caulking not included.